INSTRUCTION SUPPLEMENT
99-LATER HONDA
TRX400EX
Thumb Throttle
Attach cable into cable wheel with the cable
end at the 8:00 position of the cable wheel,
then into bracket. Secure by replacing the
cable bracket end and phillips screw. See
Figure 2.
Removing Stock Carb and Cables
1.Remove seat/fender assembly and fuel
tank.
Figure 2.
2.Remove throttle cables paying close
attention to routing.
3.Remove thumb throttle housing if you are
installing a twist throttle.
4.Remove air box and air box intake tube.
5.Remove stock carburetor.
6.Stuff a clean rag into intake manifold to
keep debris from entering engine.
Twist Throttle
Preparing machine for carburetor
installation
1.Install the pull (see figure 4 for cable
identification), cable end into the 8:00
position and the idle cable end into the
11:00 position on the cable wheel. See
Figure 3.
1. Route the provided throttle cables per
manufacturer s recommended procedure,
routing them the same as the stock cables.
Figure 3.
2.Remove the rubber alignment tabs from
the manifold using a razor blade or cutters.
Be very careful not to damage the intake
manifold!
3.Remove air box intake tube from the air
box and use a hacksaw to cut approx. 1½
off of the air box intake tube. Your tube
should resemble the one shown in Figure 1.
Re-assemble the air intake tube into air box
and install back onto bike. Don’t forget to
tighten clamp around intake tube and re-
Figure 4.
insert crank vent into the air boot.
Figure 1.
|
Concord Camera Digital Camera Eye Q User Manual
CTA Video Gaming Accessories 3DS 22K User Manual
Cub Cadet Snow Blower 190 353 100 User Manual
Cuisinart Cookware 766 26 User Manual
Delta Electronics Network Card SISN811 User Manual
D Link Printer DPR 1020 User Manual
Dukane Projector 28A9017 User Manual
Fundex Games Games Peanut Butter Jelly Card Game User Manual
GE Dishwasher CDW9380NSS User Manual
Global Machinery Company Trimmer BHT500 User Manual